Cisco TelePresence SX20 Codec

D14949.13 SX20 Codec API Reference Guide TC7.3, OCTOBER 2015. Copyright © 2015 Cisco Systems, Inc. All rights reserved. 196
Cisco TelePresence SX20 Codec API Reference Guide
xStatus SystemUnit State System
Shows what state the system is in.
InCall: The system is in a call.
Initialized: The system is ready for use.
Initializing: The system is initializing.
Multisite: The system is in a Multisite conference.
Sleeping: The system is in sleep mode.
Value space of the result returned:
<InCall/Initialized/Initializing/Multisite/Sleeping>
Example:
xStatus SystemUnit State System
*s SystemUnit State System: Initialized
** end
xStatus SystemUnit State MaxNumberOfCalls
Shows the the maximum number of simultaneous calls.
Value space of the result returned:
<0..5>
Example:
xStatus SystemUnit State MaxNumberOfCalls
*s SystemUnit State MaxNumberOfCalls: 3
** end
xStatus SystemUnit State MaxNumberOfActiveCalls
Shows the the maximum number of simultaneous active calls. Calls that are set on hold/transfer are
not counted as active.
Value space of the result returned:
<0..5>
Example:
xStatus SystemUnit State MaxNumberOfActiveCalls
*s SystemUnit State MaxNumberOfActiveCalls: 3
** end
xStatus SystemUnit State NumberOfActiveCalls
Shows the number of active calls.
Value space of the result returned:
<0..5>
Example:
xStatus SystemUnit State NumberOfActiveCalls
*s SystemUnit State NumberOfActiveCalls: 0
** end
xStatus SystemUnit State NumberOfSuspendedCalls
Shows the number of suspended calls.
Value space of the result returned:
<0..5>
Example:
xStatus SystemUnit State NumberOfSuspendedCalls
*s SystemUnit State NumberOfSuspendedCalls: 0
** end
xStatus SystemUnit State NumberOfInProgressCalls
Shows the number of calls in progress.
Value space of the result returned:
<0..5>
Example:
xStatus SystemUnit State NumberOfInProgressCalls
*s SystemUnit State NumberOfInProgressCalls: 0
** end
Contents
Introduction
About the API
xConfiguration
Appendices
xCommand
xStatusxStatus