Cisco TelePresence SX20 Codec User Manual

D14949.13 SX20 Codec API Reference Guide TC7.3, OCTOBER 2015. Copyright © 2015 Cisco Systems, Inc. All rights reserved. 51
Cisco TelePresence SX20 Codec API Reference Guide
xConfiguration Network [1..1] VLAN Voice VlanId
Set the VLAN voice ID. This setting will only take effect if VLAN Voice Mode is set to Manual.
Requires user role: ADMIN
Value space: <1..4094>
Range: Select a value between 1 and 4094.
Example:
xConfiguration Network 1 VLAN Voice VlanId: 1
NetworkServices configuration
xConfiguration NetworkServices CDP Mode
Enable or disable the CDP (Cisco Discovery Protocol) daemon. Enabling CDP will make the endpoint
report certain statistics and device identifiers to a CDP-enabled switch. If CDP is disabled, the
Network VLAN Voice Mode: Auto setting will not work.
Requires user role: ADMIN
Value space: <Off/On>
Off: The CDP daemon is disabled.
On: The CDP daemon is enabled.
Example:
xConfiguration NetworkServices CDP Mode: On
xConfiguration NetworkServices H323 Mode
Determine whether the system should be able to place and receive H.323 calls or not.
Requires user role: ADMIN
Value space: <Off/On>
Off: Disable the possibility to place and receive H.323 calls.
On: Enable the possibility to place and receive H.323 calls (default).
Example:
xConfiguration NetworkServices H323 Mode: On
xConfiguration NetworkServices HTTP Mode
Set the HTTP mode to enable/disable access to the system through a web browser. The web
interface is used for system management, call management such as call transfer, diagnostics and
software uploads.
Requires user role: ADMIN
Value space: <Off/On>
Off: The HTTP protocol is disabled.
On: The HTTP protocol is enabled.
Example:
xConfiguration NetworkServices HTTP Mode: On
Contents
Introduction
About the API
xConfiguration
Appendices
xCommand
xStatus
xConfiguration

Cisco TelePresence SX20 Codec Specifications

General

Brand	Cisco
Model	TelePresence SX20 Codec
Category	Conference System
Language	English