31-20
Catalyst 4500 Series, Catalyst 2948G, Catalyst 2948G-GE-TX, and Catalyst 2980G Switches Software Configuration Guide—Release 8.2GLX
78-15908-01
Chapter 31 Configuring 802.1x Authentication
Configuring 802.1x Authentication on the Switch
To display the global 802.1x parameters, perform this task in normal mode:
This example shows how to display the global 802.1x parameters:
Console> (enable) show dot1x
PAE Capability Authenticator Only
Protocol Version 1
system-auth-control enabled
re-authentication disabled
max-req 2
quiet-period 60 seconds
re-authperiod 3600 seconds
server-timeout 30 seconds
supp-timeout 30 seconds
tx-period 30 seconds
Task Command
Display the PAE capabilities, protocol version,
system-auth-control, and other global dot1x parameters.
show dot1x
To Next Page
Loading...
