* If none of the buttons are pressed for about 3 minutes during the chrono-
graph reset display, the watch automatically returns to the time/calendar
mode.
* The mode cannot be switched during chronograph measurement (including
when split time is being displayed).
However, when the mode is switched by pressing button (M) when the
chronograph is stopped, the time when the chronograph was stopped is
maintained.
Split Time: The amount of time that elapses from the starting point to
some intermediate point.
37
A. Chronograph Measurement
<Elapsed Time>
(1) Press button (M) to switch to the chronograph mode.
(2) Press button (A) to start or stop the chronograph.
(3) Press button (B) when the chronograph is stopped to reset.
<Split Time>
(1) Press button (M) to switch to the chronograph mode.
(2) Press button (A) to start or stop the chronograph.
(3) Pressing button (B) during measurement of elapsed time displays the split
time for about 10 seconds. The most recent split time is measured and
displayed whenever button (B) is pressed. (The SP mark flashes when
split time is being displayed.)
(4) Press button (B) while the chronograph is stopped to return the watch to
the chronograph reset display.
V
Confirmation Tone
The watch produces a confirmation tone whenever the chronograph is start-
ed, stopped, reset or the split time is displayed.
36
Split time
Split time
Starting point Goal
To Next Page
Loading...
