* Altitude and barometric pressure are alternately displayed. Altitude is displayed
in “m”, while barometric pressure is displayed in “hPa”.
* When displaying altitude and temperature differences, a comparison is made with
the values of the previous point number. A “ “ is displayed if the altitude or tem-
perature has risen, and a “ “ is displayed if the altitude or temperature has fall-
en. A series of hyphens (
----
) is displayed for the altitude and temperature differ-
ences of point no. 1 since there is no previous data for comparison.
* A series of hyphens “
----
” is displayed when there are no point memos stored in
memory.
* When there are less than six point memos in memory, only the point memos
stored in memory are repeatedly displayed whenever button (B) is pressed.
* If none of the buttons are pressed for about 3 minutes in the altitude memo
mode, the watch automatically returns to the time/calendar mode.
B. Deleting a Point Memo
All point memos are deleted by simultaneous-
ly pressing buttons (A) and (B) for at least 2
seconds. A tone confirming deletion of point
memos sounds at this time.
* Individual point memos cannot be deleted.
13. Using the Water Depth Measurement Mode
When the water sensor gets wet in any of the standard modes (except during
chronograph measurement), the watch automatically switches to the water
depth measurement mode (preliminary dive display). When water depth
exceeds 1 meter during the preliminary dive display, water depth measurement
begins, and water depth is measured once every second.
4948
To Next Page
Loading...
