<Elapsed Time Measurement>
Measurement of elapsed time starts automatically
when the watch is initially switched to the continu-
ous altitude measurement display.
The amount of time that elapses from the start of
altitude measurement during the continuous altitude
measurement display or fixed duration altitude mea-
surement display is measured and displayed.
Pressing button (A) during measurement of elapsed
time causes a tone confirming button operation to
sound and makes it possible to stop and resume
measurement of elapsed time.
* During measurement of elapsed time, the colon (:)
of digital display [2] flashes. The colon is dis-
played continuously when measurement is
stopped.
• Elapsed time measuring range : 0 hours 00 minutes to 23 hours 59 minutes
(in 1 minute units)
* Measurement repeats after 24 hours have
elapsed.
67
* If none of the buttons are pressed for about 10 seconds after performing
the procedure of (1) or (2) above, the watch automatically returns to the
altitude measurement display. Time is not stored in memory if the proce-
dure of (2) is not performed.
* A maximum of 6 altitude memos can be stored in memory. When button
(A) is pressed for at least 2 seconds after storing 6 points of altitude
memos in memory, “FL” and “
————
” are displayed and data is not stored in
memory. If additional memos are desired to be stored in memory, it is nec-
essary to delete all point memos in the altitude memo mode of the standard
mode.
66
<Display when Measurement
is in Progress>
<Display when Measurement
is Stopped>
(A)
To Next Page
Loading...
