Citizen CL-S400DT - Page 36

36
Chapter 2 Printer Operation
Top Menu Sub Menu Default Menu Remarks
Cutter Action Backfeed Backfeed
Through
Sets the cutter action.
With the optional AutoCongure On,
printing is executed only when the cutter
is installed or only when Cut is selected by
Function Select.
Backfeed is always set after cutting.
Through is set at the rear end of sheets 1 to
n-1 when the number of copies = n, and the
rear end of the nal page of single sheet and
the copy is backfeed.
Peel Wait Delay* 0.1 sec 0.1 to 2.0 sec Sets the Peel Wait Delay.
Displays only machines with a peeler
installed.
Paper Position 0.00 inch
0.0 mm
Peel/Cut/Tear O
0.00 to 2.00 inch
0.0 to 50.8 mm
Peel/Cut/Tear On
-1.00 to 1.00 inch
-25.4 to 25.4 mm
Adjusts the stop position. It is based on the
inch/millimeter setting. There are initial
values of the stop position for each device
set above, and later, relative values are set.
Menu Key Action Enters Menu Enters Menu
Repeat Label Set
Repeat Last One
Sets the menu key action.
Enters Menu:
Enters the menu setup mode.
Repeat Label Set:
Repeats the number of copies.
Repeat Last One:
Last one is issued only for the nal page.
In the case of a count, afterwards, only
last one is issued.
Note: Hold down the MENU key for at least
4 seconds in order to enter the Menu Setup
Mode when setting the “Repeat Label Set” or
“Repeat Last One” menus.
Interfaces RS-232C Baud 9600 115200
57600
38400
19200
9600
4800
2400
Setting the baud rate of the serial interface.
• All settings related to the interface are
enabled after the power is reconnected.
RS-232C Parity None None
Odd
Even
Setting the communication parity for the
serial interface.
RS-232C Length 8 bits 8 bits
7 bits
Setting the character length for the serial
interface.
RS-232C Stop bit
[RS-232C Stopbit]
1 bit 1 bit
2 bits
Setting the stop bit for the serial interface.
RS-232C X-ON Yes Yes
No
Selectively setting the X-ON ow control of
the serial interface.
IEEE1284 On On
O
Setting both direction of the Centro
Interface.
* Only when cutter is mounted.
Mode Settings
[Datamax® Emulation]