Citizen CL-S400DT - Page 37

37
Chapter 2 Printer Operation
Top Menu Sub Menu Default Menu Remarks
Web Monitor* Auto Auto
On
O
Selecting the web monitor function.
Network Address** 0.0.0.0 0.0.0.0 to
255.255.255.255
Setting xed IP address of the LAN board.
Subnet Mask** 0.0.0.0 0.0.0.0 to
255.255.255.255
Setting xed subnet mask value of the LAN
board.
Gateway Address** 0.0.0.0 0.0.0.0 to
255.255.255.255
Setting xed default gateway address of the
LAN board.
BOOTP** O On
O
Setting the BOOTP of the LAN board.
DHCP** O On
O
Setting the DHCP of the LAN board.
USB Device Class
[USB Device Clas]
Printer Printer
VCOM
Selects the USB device class.
USB VCOM Protocol
[VCOM Protocol]
Auto Auto
DTR
X-ON
Selects the protocol (ow control) when
operating USB VCOM.
Machine
Information
[Machine Info]
Model Number – CL-S*** Displays the model name.
Boot Version – *.* Displays the boot version.
ROM Version – ******** Displays the ROM version.
ROM Date – **/**/** Displays the date the ROM was prepared.
ROM CheckSum – **** Displays the check sum of the ROM.
FPGA Version – ****.**** Displays the FPGA version.
Head Check – OK
NG
Displays the results of the head check.
Print Counter – ****.*** km Displays the print counter.
Service Counter – ****.*** km Displays the service counter.
Cut Counter – ******* Displays the cut count.
Sensor Monitor – *.* V Displays the sensor level.
Option Interface
[Option I/F]
– None
IEEE1284
LAN
Displays the presence/absence of the
optional interface.
Test Mode Print Pattern Current Cong Current Cong
Global Cong
Sample
Executes the test pattern.
Head Check No Yes
No
Executes head check.
Factory Default No Yes
No
Initializes the set values of the conguration
set to the state when the unit was shipped
from the factory.
Hex Dump No Yes
No
Sets the hex dump mode.
* Displayed when equipped with a SEH LAN board.
**Displayed when the Web Monitor is operating.
Mode Settings
[Datamax® Emulation]