Citizen CLP-521 - Understanding LED Indicators; Warning and Error Indications

Chapter 3 Adjustments
CLP-521, CLP-621 & CLP-631 3-4
Notes:
- With the original factory settings, the printer automatically recognizes installation of the
Auto Cutter Unit.
- If cutting operation is not performed, "Auto Configure" option in the "After Print" menu may
be set to "Off". In this case, set it to "On" and then retry self test print operation.
*: To change the menu setting, refer to the User's Manual.
- Cutter operation is possible even when "Auto Configure" option in the "After Print" menu is
set to "Off". To enable the cutter operation, select "Cut On" in "Function Select" of the "After
Print" menu, and then perform self test print operation.