Chapter 2 Printer Operation
25
3 Printer Configuration Setting Mode
In this menu, the print mode, the 'after printing function' such as cutting or peeling, media
sensor selection and print quality settings such as print speed or density are configured. Control
key functions are shown below. The printer configuration settings are stored in memory so they
are maintained even after the power is turned off.
Example: Changing the media gap sensor to the black mark sensor
1. First check the printer goes On Line, then press and hold down the PAUSE key and press the
FEED key.
2. Change the print mode (direct-thermal or thermal transfer printing) to the sensor selection with the
PAUSE key.
3 Printer Configuration Setting Mode
To Next Page
Loading...
