Chapter 2 Printer Operation
29
Notes when setting print start position and media stop position
• When the "AfterPnt" menu item is set to "AutoCut", the relation between print start position and
media stop position should be set to [(O ( (f]. If the value is set so that [(O < (f], the media may be out
of platen.
• If the absolute value to O value is larger than the absolute value to f value as the set value of [(O]
increases, the media stop position may change. However, if the absolute value to f value is smaller
than the absolute value to O value as the set value of [(f] decreases, the media stop position may
not change.
• When the "AfterPnt" menu item is set to "PeelWait", the set value of [(f] should be limited; the larger
value causes labels to unexpectedly peel off.
3 Printer Configuration Setting Mode
To Next Page
Loading...
