53
Sub Menu Menu items Options Description
Network DHCP ON
OFF
You can set whether to enable
or disable the DHCP function.
If DHCP is enabled, the IP
address of the specified SSID
Gateway will be applied.
Note:
This settting can be set
when “Infrastructure” is selected
for Connection Type.
IP Address — You can set the IP address to be
applied.
Note:
If you set Connection Type
to “SoftAP” or DHCP to ON, this
menu cannot be used.
Subnet — The subnet mask can be set.
Note:
If you set Connection Type
to “SoftAP” or DHCP to ON, this
menu cannot be used.
Gateway — The IP address for an access
point can be set.
Note:
If you set Connection Type
to “SoftAP” or DHCP to ON, this
menu cannot be used.
DNS — If using a DNS server, enter the
address.
Note:
If you set Connection Type
to “SoftAP” or “Adhoc”, or set
DHCP to ON, this menu cannot
be used.
Traffic — — You can confirm the traffic
(transmitted and received data,
etc.) of each protocol (ETH ARP,
IP, TCP and UDP).
Security CA — You can configure the settings
for a digital certificate. PEM
format files are only supported.
Client —
Key —
WPS WPS Type PBC You can set WPS.
Note:
Note: This setting can be
set when
“
Infrastructure
”
is
selected for Connection Type.
Etc Reboot — You can apply the setting to the
printer.
Firmware Update — The firmware can be updated.
V10 CONSUMIBLES S.L.
Calle Llanos de Jerez 18 Nave 9 Coslada https://v10consumibles.com Tel: 910 269 309
To Next Page
Loading...
Need help?
General
