Citizen CT-E651 - Page 28

28
——
3.4 Ethernet (LAN)/Wireless LAN Interface Board
This section provides an overview of the interface board. For details about this board,
refer to the separate manual.
Panel button operation
Board operations are performed using the panel button on the rear of the LAN board.
Panel button Panel button
Ethernet Wireless LAN
 Enabling LAN connection
Turn on the printer. Operation of this board will start about 20 seconds later.
 Printing LAN setup information
Press the panel button.
 Entering setting mode
Hold down the panel button. A buzzer* will sound once to indicate that setting mode
has been entered.
 You can use setting mode to read factory settings.
 If you do not perform any operation for three seconds while in setting mode, a
buzzer* will sound once to indicate the board has returned to normal mode.
* Depending on the printer model and settings, the buzzer may not sound.
 Returning to factory settings
Enter the board setting mode, and then hold down the panel button. This returns the
board to its factory settings.
CAUTION
The board will automatically restart after this operation is complete. After clearing settings, you
will need to re-congure network settings.