Citizen CT-S280

— 22 —
5.3 Ajuste Manual de los “Memory Switches”
Los “memory switches” pueden ser ajustados manualmente o vía comando. Para el
ajuste manual, consulte la siguiente página.
En la siguiente tabla se muestra la función de cada “memory switch”.
(Los caracteres blancos sobre fondo negro son ajustes de fábrica.)
No. de Conmutador Ajuste 0 (OFF) 1 (ON)
Memory SW1-1 Power ON Info Send Not send
Memory SW1-2 Buffer Size 4k bytes 45 bytes
Memory SW1-3 Busy Condition Full/Err Full
Memory SW1-4 Receive Error Print “?” Invalid
Memory SW1-5 CR Mode Ignored LF
Memory SW1-6 Reserved Fixed −
Memory SW1-7 DSR Signal Invalid Valid
Memory SW1-8 Reserved Fixed −
Memory SW2-1 Reserved − Fixed
Memory SW2-2 Reserved Fixed −
Memory SW2-3 Spool print Invalid Valid
Memory SW2-4 Full col print LineFeed WaitData
Memory SW2-5 Resume aft PE Print next line Print top
Memory SW2-6 Reserved − Fixed
Memory SW2-7 Reserved Fixed −
Memory SW2-8 PNE sensor Valid Invalid
Memory SW3-1 Reserved Fixed −
Memory SW3-2 Reserved Fixed −
Memory SW3-3 Parallel 31 Pin Valid Invalid
Memory SW3-4 Reserved Fixed −
Memory SW3-5 Reserved Fixed −
Memory SW3-6 Reserved Fixed −
Memory SW3-7 CBM-270 mode Invalid Valid
Memory SW3-8 Resum Open Err Close Command