the LO symbol will be on to the left side of the display.
Enter the low limit in the same way the high limit was entered.
After pressing the ZERO key the scale will return to weighing with
the Check-weighing function enabled.
When a weight is placed on the scale the arrows will show if the
weight is above or below the limits and the beeper will sound as
described below.
BOTH LIMITS SET
The display will show OK and the beeper will sound when
the weight is between the limits.
LOW LIMIT SET, HIGH LIMIT is set to zero
The display will show OK and the beeper will sound when
the weight is less than the Low Limit. Above the Low
Limit the display will show HIGH and the beeper will be
off.
HIGH LIMIT SET, LOW LIMIT is set to zero
The display will show LOW and the beeper will be off
when the weight is less than the High Limit. Above the
High Limit the display will show OK and the beeper will be
on.
BOTH LIMITS SET. LOW is set greater than HIGH
The beeper will never sound and the display will show
LOW if the weight is less that the LOW limit, and HIGH if
the weight is greater than the Low Limit.
NOTE: The weight must be bigger than 20 scale divisions for the
checkweighing to operate.
To disable the Check-Weighing function enter zero into both limits by
pressing the FUNC key when the current limits are shown then pressing
the ZERO key to store the zero values.
Note: you can set high/low limit in all normal weighing,
percentage weighing and counting mode.
-5-
3. 7 ACCUMULATED TOTAL
The scale can be set to accumulate automatically when a weight is
added to he scale or manually by pressing the PRINT key. See the
PARAMETERS Section in technical manual for details of selecting the
method . The accumulation function is only available when weighing. It
is disabled during percent weighing or parts counting.
3. 8 MANUAL ACCUMULATION
When the scale is set to manual accumulation the weight displayed
will be stored in memory when the PRINT key is pressed and the weight
is stable.
The display will show "ACC 1" and then the total in memory for 2
seconds before returning to normal. If the optional RS-232 interface is
installed the weight will be output to a printer or PC.
Remove the weight, allowing the scale to return to zero and put a
second weight on. Press PRINT, the display will show "ACC 2" and
then show the new total.
Continue until all weights have been added.
To view the totals in memory press the PRINT key when the scale is
at zero. The display will show the total number of items "ACC xx" and
the total weight before returning to zero. The totals will also be printed
via the RS-232 interface.
To erase the memory press PRINT to view the totals and then press
the FUNC key to clear the memory.
3. 9 AUTOMATIC ACCUMULATION
When the scale has been set to Automatic Accumulation the value is
stored in memory automatically.
Add a weight to the scale, the beeper will sound when the scale is
stable to signify the value is accepted. Remove the weight, the display
will show "ACC 1" and the totals in memory when the scale returns to
zero. Adding a second weight will repeat the process.
While the weight is on the scale it is permissible to press the PRINT
key to store the value immediately. In this case the scale will not store
-6-
the value when the weight is removed. The totals can be viewed as
To Next Page
Loading...
Need help?
General
