Citizen CX 220 - Page 42

81
Printouts generated when Unit Toggling is done
between Application Unit (Den with Compensated
Mode Liquid as Ethanol), Unit1 and Unit2 and
Reference Weight is changed
Printouts generated when Unit Toggling is done
between Application Unit (Den with Uncompensated
Mode and Liquid as None), Unit1 and Unit2 and
Reference Weight is changed
When GLP ON When GLP ON
-----------------------------------
28-Jul-10 03:19PM
Citizen
Model CX 220
Ser.no. 9223102
Ver.no. r0.1.5.3
ID 1234567
-----------------------------------
-----------------------------------
28-Jul-10 03:23PM
Name:
................
-----------------------------------
Mode COMPENSATED
Liquid ETHANOL
Temperature 28.0
Den + 0.6995g/c3
+ 18.9350 g
+ 94.675 ct
-----------------------------------
28-Jul-10 03:19PM
Citizen
Model CX 220
Ser.no. 9223102
Ver.no. r0.1.5.3
ID 1234567
-----------------------------------
-----------------------------------
28-Jul-10 03:23PM
Name:
................
-----------------------------------
Mode UNCOMPENSATED
Liquid OTHER
Temperature NA
Den + 0.6994g/c3
+ 18.9350 g
+ 94.675 ct
Printouts generated when Unit Toggling is done
between Application Unit (Den), Unit1 and
Unit2 and Reference Weight is changed
Printouts generated when Unit Toggling is done
between Application Unit (Den), Unit1 and
Unit2 and Reference Weight is changed
When GLP ON When GLP OFF
-----------------------------------
28-Jul-10 03:19PM
Citizen
Model CX 220
Ser.no. 9223102
Ver.no. r0.1.5.3
ID 1234567
-----------------------------------
-----------------------------------
28-Jul-10 03:23PM
Name:
................
-----------------------------------
Mode GOLD
Liquid WATER
Temperature 25.0
Pur + 23.1 ct
+ 18.9350 g
+ 94.675 ct
Mode GOLD
Liquid WATER
Temperature 25.0
Pur + 23.1 ct
+ 18.9350 g
+ 94.675 ct
If the balance is connected externally to PC or Printer through RS 232 C then, whenever user enter into the menu of Density function & make
changes in the, automatically printout is generated on the Peripheral attached.
In the printout, Temperature, Liquid and Mode are printed. After this user can Press Print Key to Print the reading on the display.
Also user can Toggle to other unit through Toggle key & Press Print Key to get the print out of those corresponding units.
If the balance is connected externally to PC or Printer through RS 232 C then, whenever user enter into the menu of Density function & make
changes in the, automatically printout is generated on the Peripheral attached.
In the printout, Temperature, Liquid and Mode are printed. After this user can Press Print Key to Print the reading on the display.
Also user can Toggle to other unit through Toggle key & Press Print Key to get the print out of those corresponding units.
Note : 1) User cannot enter into the external calibration or menu when GLP is ON
2) To print footer user will have to Press <CANCEL> key.
& footer has not been printed.
Note : 1) User cannot enter into the external calibration or menu when GLP is ON
2) To print footer user will have to Press <CANCEL> key.
& footer has not been printed.
82