Need help?Do you have a question about the Citizen CY 320 and is the answer not in the manual?
Essential safety guidelines for balance operation, including electrical safety, handling liquids, and equipment integrity.
Guidance on proper storage, unpacking, and identification of supplied accessories for the balance.
Detailed identification of key components, controls, and connection ports across different balance models.
Recommendations for balance placement to ensure accuracy, avoiding environmental factors like sunlight and drafts.
Information on the required warm-up time for the balance to achieve accurate weighing results.
Explanation of the function of each key on the balance control panel and display symbols.
Details on using balance keys for brief presses and press-and-hold actions during weighing operations.
Steps for performing basic weighing and tarring operations on the balance pan.
How to change weight units and understand the balance's printout formats.
Details of successful and unsuccessful external calibration reports.
Details of successful and unsuccessful internal calibration reports.
Details of calibration test reports, showing differences between weights.
Details of calibration test reports, showing differences between weights.
Explanation of key operations for navigating and using the balance's user menu.
Step-by-step guide to navigate and use the balance's menu system.
Overview of various application menus and their functionalities.
Introduction to built-in applications like Piece Counting, Percent Weighing, and Custom Units.
How to adjust the stability filter to match ambient conditions for better accuracy.
Choosing between External and Internal calibration methods.
Options for performing a calibration test to verify balance accuracy.
Enabling or disabling the auto zero tracking feature to maintain zero point.
Configuration of data transmission speed and parity for serial communication.
Setting the stop bit parameter for serial data transmission.
Setting data transfer modes and GLP compliance for printouts.
Configuring automatic standby mode and resetting balance settings to factory defaults.
How to perform piece counting using reference settings.
Setting custom references (FREE) and entering known weights (wRef) for counting.
Improving piece counting precision by updating the average piece weight.
Setting custom reference percentages for the percent weighing function.
Setting a user-defined factor for custom unit calculations.
Selecting display accuracy and least significant digit for custom units.
Performing manual animal weighing with countdown and averaging options.
Automatic animal weighing using countdown and averaging for unstable samples.
Performing manual formulation by sequentially adding and summing weights.
Automatic formulation by sequentially adding and summing weights.
Setting target, high, and low values for check weighing analysis.
Performing manual totalization by sequentially adding weights.
Automatic totalization by sequentially adding weights.
Setting the temperature of the liquid for density measurement.
Selecting the type of liquid (water, ethanol, other) for density measurement.
Selecting measurement modes: compensated, uncompensated, or gold purity.
Configuring count cycles, temperature, and pressure for pipette calibration.
Setting initial, half, and full volumes and executing the calibration procedure.
Steps to perform statistical analysis and view results like average and deviation.
Explanation of key operations for navigating and using the parameter settings menu.
Setting identification numbers, lot identification, current time, and date.
Configuring automatic calibration based on time, temperature, or power-on.
Configuring time intervals and temperature thresholds for automatic calibration.
Enabling or disabling calibration that occurs automatically upon power on.
Configuring balance settings like unit output and communication mode for Windows.
Setting the data separator (Enter or Tab) for communication with Windows.
Details of the balance's data output format, including character positions and codes.
Format for sending commands to the balance from a computer interface.
Guidelines for balance servicing, maintenance, and general cleaning.
Safety checks for the DC adapter and balance operation to ensure continued safe use.
Detailed technical specifications for various Analytical Balance models.
Detailed technical specifications for various Precision Balance models.
Detailed technical specifications for Top Loading Precision Balance models.
Detailed technical specifications for High Capacity Precision Balance models.
Detailed technical specifications for various Carat Balance models.
To Next Page
General
