10.
Zero
Positioning
of
Chronograph
Second
Hand
When
resetting the chronograph, ifthe chronograph second hand does not
return to the 0
seconds
position or if the chronograph second had has shifted
out of position due to strong impact, perform zero positioningof the
chronograph
second
hand according to the procedure described below.
• In the
case
the crown is of the screw-lock type, loosen the screw before
operating
the
crown.
• The zero positioning procedure cannot be performed while the insufficient
chargingwarning feature is activated (whilethe second hand is moving at 2-
second intervalmovement due to the watch being insufficientlycharged).
Sufficiently charge the watch and check that the second hand is moving at 1-
second intervalmovement before performingthe zero positioning procedure.
20
To Next Page
Loading...
