The dot display symbols and their meaning
<Mode display>
: Time calendar mode
: Alarm mode
: During the measurement of temperature
: Log mode (The display when there is no
profile data recorded)
: Log mode (The display when profile data
has been recorded)
: Surface mode (Time elapsed after
completing a valid dive)
: Transfer mode
: Data presently being transferred
: Dive mode (Diver is swimming)
: Ready for diving
Warning Display
: Ascending speed warning
: (D201/D207) / (D202/D208): Battery Warning
: Various checks (*without (D202/D208))
: Various errors
*Please look at the N. [The log mode] for an
explanation about profile data.
G. How to change the mode
The mode changes by pressing button
M
or when
the water sensor gets wet.
* Surface mode cannot be acquired unless a valid
dive is done.
* Change to the transfer mode by pressing the
M
button for more than 2 seconds from any mode.
*Change to the transfer mode by pressing
M button
for more than 2 seconds from any mode.
M : Press (M) button once
M
: Press (M) button for more than 2 seconds
: Displayed only in surface mode
: Auto return
H. Time and calendar mode
[This is the function which displays present time and
present calendar.]
• In normal time mode, a LED, which is situated at
12 o’clock, flashes a time signal for 3 seconds on
every hour. (ex 7:00:00, 01, 02)
• By pressing
A button in the time and calendar
mode, the watch is in temperature measuring state
(1st temperature display state). In this mode the
temperature is measured every 10 seconds for 3
minutes. However, until the first measurement is
taken it displays [--°C].
• After 3 minutes the watch automatically changes to
(the 2nd temperature display state) where
temperature is measured every 30 minutes. The
range of temperature measurement is between –
5°C to 40°C (23°F~104°F). However, while the
watch is on your wrist the correct temperature
cannot be measured properly, so please remove
the watch from your wrist to get accurate readings.
• In the time and calendar mode, you can confirm
the LED flashes by pressing the
B
button once.
(Flashes 5 times)
• The display light will stay on for up to 10 seconds
while you press
C
button. The display light will
switch off 1.5 seconds after releasing the C
button.
To Next Page
Loading...
