Why does my Citizen Printer not wind paper?
If your Citizen printer does not wind paper, check the following: * Ensure the paper end is correctly inserted into the slit of the winder reel. * Verify that the motor connector is properly connected. * Confirm the AC supply voltage is correct. * Clear any paper jams. * If the supply voltage is normal, replace the motor assy AW if it's defective.
Details critical warnings about equipment handling, potential hazards, and fire risks.
Guidelines for safe and proper installation environment and conditions.
Instructions for safe operation, avoiding damage, and preventing injury.
Provides comprehensive technical specifications for various printer models.
Details recommended paper types, widths, and thicknesses for different models.
Steps for connecting serial and parallel interface cables to the printer.
Procedure for connecting the drawer kick-out connector with safety caution.
Procedures for loading paper rolls and fan-fold paper, including cautions.
Procedure for clearing paper jams and troubleshooting.
Explanation of printer status indicators, lamps, and error messages.
Detailed settings for DIP Switch 1 and 2, including international character selection.
Explains how to select CBM, Star, and ESC/POS modes using DIP switches and jumpers.
Technical details of the 8-bit parallel data system and control signals.
Description of input, output, and power-related signals for the parallel interface.
Details asynchronous system, baud rates, and data transmission configuration.
Description of signals like RXD, DTR, TXD, DSR, FAULT, RESET for serial communication.
Details error detection methods and buffering mechanisms for serial data.
Details drive voltage, current, and signal levels for the drawer kick-out.
Lists and describes commands for the CBM print mode.
Lists and describes commands for the Star print mode.
Lists and describes commands for the ESC/POS print mode.
To Next Page
General