DS 19 OPERATION No. DS 133-1 : Work on the engine mountings. Op. DS 133-1 98
TOOLS
REPLACEMENT OF A REAR FLEXIBLE MOUNTING SUPPORT (cars produced before July 1959)
Removal (see Pl. 24).
61 Remove the spindle of the flexible mounting (see paragraphs 23 to 28, this operation).
62 Remove the screws fixing the flexible mounting (13) on the support (4) and remove the flexible mounting . . . . . 14 mm box spanner
63 Remove the nuts fixing the support (4) and remove the support . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 14 mm spanner
Assembly (see Pl. 24)
64 Place the support in position, fit the fixing nuts, without tightening (plain and spring washers).
65 Place the rubber block in position on the bracket and insert the fixing screws without tightening (plain and spring
washers under the heads).
66 Engage the spindle (8), complete with rubber washer and fibre washer (9), the rubber block (11), the cupped nut (5)
and the locknut (12) in the flexible mounting (13).
67 Place the steel cup (7) in position and tighten the nut (6). Have the cupped nut (5) held from underneath the car by
an assistant (spanner 1700-T, see fig. 3) . . . . . . . . . .. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Spanner 1700-T
23 mm box spanner
68 Tighten the lower nut (3) of the arm (2) until the measurement “a” mentioned in paragraph 26 is obtained.
69 Engage the spindle (8) in the bore of the arm (2). Gently lower the engine and engage the shoulder of the nut (3)
in the bore of the arm (2). Fit and tighten the upper nut (1) on the arm (2) . . . . . . . . . . . . . . . . . . . . . . . . . . . . 23 mm box spanner
70 Tighten the screws fixing the flexible mounting (13) on the support (4) (plain and spring washers under the heads)
and tighten the nuts fixing the steel support (4) on the body (pain and spring washers) . . . . . . . . . . . . . . . . . . 14 mm spanner
14 mm box spanner
71 Left-hand side : replace the distributor return spring.
Right-hand side: fit the exhaust manifold screen. Tighten the fixing screws (plain and spring washers under the
heads). . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12 mm box spanner
72 Lower the car to the ground (jacking bracket 2505-T, see Pl. 168). Remove the chain sling 1687-T . . . . . . . . . . Jacking bracket 2505-T
Chain sling 1697-T
73 Check the adjustment of the engine mountings. Re-adjust if necessary (see Op. DS 133-0).
To Next Page
Loading...
