CITROEN DS 19 - Page 99

DS 19 OPERATION No. DS 133-1 : Work on the engine mountings. Op. DS 133-1 97
TOOLS
PRE-ADJUSTMENT OF THE REAR FLEXIBLE ENGINE MOUNTING (cars produced since July 1959)
50 Bring the upper face of the lower nut tightening the arm, to a distance of 98 mm from the bearing face of the
flexible mounting on the steel support on the body . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 21 mm spanner
REPLACEMENT OF A REAR ARM (cars produced before July 1959)
Removal (see Pl. 24).
51 Put the front of the car on stands (jacking bracket 2505-T, see Pl. 168) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Jacking bracket 2505-T
52 Left-hand support arm : unhook the distributor return spring.
Right-hand support arm: remove the exhaust manifold screen . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12 mm box spanner
53 Remove the upper arm (1) fixing the arm (2) on the flexible mounting . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 23 mm box spanner
54 Place a covered chain sling around the water pump cover (chain sling 1697-T, see Pl. 51) and support the engine
on a chain block . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Chain sling 1697-T
55 Remove the screws fixing the rear arm (2) and remove the arm . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 14 mm spanner
17 mm spanner
17 mm box spanner
Assembly (see Pl. 24).
56 Place the rear arm (2) in position and tighten the fixing screws (spring washers) . . . . . . . . . . . . . . . . . . . . . . . . . . 14-17 mm spanners
14-17 mm box spanners
57 Engage the spindle (8) in the bore of the arm (2). Lower the engine slightly and engage the shoulder of the nut (3)
in the bore of the arm (2). Tighten the upper nut (1) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 23 mm box spanner
58 Left-hand side : hook on the distributor return spring.
Right-hand side: fit the exhaust manifold screen . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12 mm box spanner
59 Lower the car to the ground (jacking bracket 2505-T, see Pl. 168). Remove the chain sling 1697-T . . . . . . . . . . Jacking bracket 2505-T
REPLACEMENT OF A REAR ARM (cars produced since July 1959)
60 Proceed as indicated for the replacement of a flexible mounting (see paragraphs 38 and onwards, this operation).