DS 19 OPERATION No. DS 133-1 : Work on the engine mountings. Op. DS 133-1 96
TOOLS
Refitting.
42 Fit the arm on the flexible mounting previously adjusted (see paragraph 50) and tighten the upper nut on the arm
(shakeproof washer) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 23 mm box spanner
43 Fit the flexible mounting and support arm assembly on the car. Insert and tighten the fixing screws of the flexible
mounting and support arm, after having correctly positioned these parts (spring washers under the heads of
the screws fixing the arms, plain washers and spring washers under the heads of the screws fixing the
flexible mounting) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 14-17 mm spanners
14-17 mm box spanners
44 Left-hand side : hook on the distributor return spring.
Right-hand side: fit the exhaust manifold screen. Tighten the fixing screws (plain washers under the heads of
the screws) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12 mm box spanner
REPAIRING A FLEXIBLE MOUNTING AFTER REMOVAL (cars produced before July 1959)
Dismantling (see Pl. 24).
45 Remove the spindle (8), the rubber washer and fibre washer (9), the rubber block (11), the cupped nut (5) and the
locknut (12).
Clean the parts.
Assembly (see Pl. 24).
46 On the spindle (8), fit the rubber washer and fibre washer (9), the rubber block (11), the cupped nut (5) and the
locknut (12).
PRE-ADJUSTMENT OF THE REAR FLEXIBLE ENGINE MOUNTING (cars produced before
July 1959) (see Pl. 24)
47 Tighten the cupped nut (5) until the upper face of the washer (9) comes into contact with the face “d” of the
support (4). The washer (9) must turn freely, without play . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 23 mm box spanner
48 Hold the spindle (8) by the nut (6) fixing the cup (7) and tighten the cupped nut (5) eight complete turns, which
corresponds to a movement of 10 mm . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 23 mm spanner
23 mm box spanner
49 Tighten and lock the locknut (12) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 23 mm spanner
23 mm box spanner
To Next Page
Loading...
