DS 19 OPERATION No. DS 133-1 : Work on the engine mountings. Op. DS 133-1 95
TOOLS
Assembly (see Pl. 24).
30 Offer up the flexible mounting on the support plate (4), fitted with the distance piece (14) and the steel cup (15).
31 Insert the spindle (8) complete with the rubber washer and fibre washer (9), the rubber block (11), the nut (5) and
the locknut (12) in the flexible mounting.
32 Place the steel cup (7) in position and tighten the nut (6). Hold the nut (5) from underneath the car (spanner 1700-T,
see fig. 3) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 23 mm box spanner
Spanner 1700-T
33 Tighten the lower nut (3) on the arm (2) until the measurement “a” measured in paragraph 26 is obtained.
34 Engage the spindle (8) in the bore of the arm (2). Gently lower the engine and engage the shoulder of the lower
nut (3) in the bore of the arm (2).
35 Insert and tighten the screws securing the flexible mounting on the steel support (4). Tighten the upper nut (1) on
the arm (2) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 14-23 mm box spanners
36 Left-hand side : hook on the distributor return spring.
Right-hand side: fit the exhaust manifold screen. Tighten the fixing screws (plain washers under the heads) . . . . 12 mm box spanner
37 Lower the car to the ground (jacking bracket 2505-T, see Pl. 168). Remove the chain sling 1697-T.
REPLACEMENT OF A REAR FLEXIBLE MOUNTING (cars produced since July 1959)
Removal.
38 Left-hand side : unhook the distributor return spring.
Right-hand side: remove the exhaust manifold screen . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12 mm box spanner
39 Pass a covered chain sling (chain sling 1697-T, see Pl. 51) round the water pump cover and suspend the engine on
a chain block . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Chain sling 1697-T
40 Remove the screws fixing the support arm on the engine and the screw fixing the flexible mounting on the body
support. Disengage the flexible mounting and the support arm . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 14-17 mm spanners
14-17 mm box spanners
41 Remove the upper nut fixing the arm on the flexible mounting and disconnect the arm from the flexible mounting 23 mm box spanner
No work is possible on the flexible mounting.
To Next Page
Loading...
