CITROEN DS 19 - Page 141

DS 19 OPERATION No. DS 211-1 Work on the contact breaker. Op. DS 211-1 139
TOOLS
REPLACEMENT OF A CONTACT BREAKER (with one breaker).
25 If any difficulty is experienced, proceed as indicated in ID 19 Repair Manual, operation ID 211-1.
REPLACEMENT OF A VARIABLE IGNITION CONTROL.
Removal.
26 Hold the bonnet open (stop MR-4158, see Pl. 16, fig. 1). . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Stop MR-4158
27 Unscrew the fixing screw of the cable, on the movable plate of the contact breaker and unscrew the cable sheath
fixing screw on the contact breaker fixing plate . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 mm spanner
8 mm box spanner
28 Remove the glove box. Hold the body of the mechanism (behind the dashboard) and unscrew the hollow screw
found behind the control (inside the car) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 14-17 mm spanners
29 Remove the control assembly from the body of the mechanism, through the opening for the glove box.
Refitting.
30 Engage the mechanism and cable assembly through the opening for the glove box. Fit the cable and sheath
assembly through the hole in the scuttle panel; make sure that the rubber grommet is fitted.
31 Fit a shake-proof washer between the body of the mechanism and the inside of the instrument panel and fit the
control in the body of the mechanism, inserting a chromium plated washer between the dashboard and the
hexagon of the hollow screw.
Hold the body of the mechanism and tighten the hollow screw of the control assembly . . . . . . . . . . . . . . . . . 14-17 mm spanners
32 Fit the glove box (cup washers under the heads of the screws).
33 Connect the cable to the movable plate of the contact breaker and connect the cable sheath on the contact breaker
fixing plate . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 mm spanner
8 mm box spanner
34 Set the firing point (see Op. DS 211-0).