DS 19 OPERATION No. DS 334-1 : Work on the gear control. Op. DS 334-1 229
PARTICULAR POINTS
Replacement of a gear selector lever.
Removal.
1 In order to carry out this operation it is necessary to remove the facia board.
2 Put the selector lever in the 1st speed position. Place the setting rod (2429- T) in the hydraulic gear selector.
4 Disengage the selector, leaving the auxiliary clutch control rod connected on the hydraulic gear selector.
Refitting.
6 Check that the gear selector lever is in the 1st speed position before connecting to the hydraulic gear selector.
7 Pull the auxiliary clutch control rod as far as possible towards the front and the lever pressed towards the rear, then fix the rod in the
trunnion of the lever.
Replacement of a hydraulic gear selector.
Refitting.
21-22 Put the sliding valve in the 1st speed position, the rod (2429- T) engaged in the locating hole and offer up the hydraulic gear selector on the
gear selector lever which should also be in the 1st speed position.
26 The hydraulic gear selector being in position, remove the locating rod.
27 Pull the auxiliary clutch control rod as far as possible towards the front and the lever pressed towards the rear then fix the rod in the
trunnion of the lever.
35 Bleed the hydraulic gear selector (see Op. DS 334-0).
36 Adjust the slow running, the clutch clearance, the clutch drag and the clutch engagement control.
TOOLS
REPLACEMENT OF A GEAR SELECTOR LEVER
Removal (see Pl. 67).
1 To remove the dashboard :
Remove the negative cable from the battery.
Remove the cover from the dashboard; remove the fixing screws, right-hand side and remove the anchor plates.
Remove the upper part of the glove box. Through this opening, remove the two screws fixing the facia board
surround. Remove the facia board surround.
Remove the screws fixing the facia surround, the nuts fixing the facia board, the earth wire, disconnect the
speedometer cable, disconnect the wires and remove the facia board . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8 mm spanner
12mm spanner
8 mm box spanner
To Next Page
Loading...
