CLA-VAL CV-Log-35
Communicating Data Logger
CLA-VAL Europe www.cla-val.ch cla-val@cla-val.ch 8 - CLOG35UE A 07/22
© Copyright CLA-VAL Europe - Specifications subject to change without notice - no contractual illustrations. Reduce your waste - Sort your rubbish
5.3.2 ORIENTABLE BRACKET MOUNTED INSTALLATION
An alternative optional orientable wall-mounted or valve bracket for CV-Log-35.
5.3.3 RECOMMENDED INSTALLATION
Depending on the cellular network signal strength, the CV-Log-35 installation might need to be adapted. The network signal
quality values mentioned below are indicative and correspond to a signal acquired with a High-Performance Cellular Signal
and Network Analyzer, reference: Siretta® «SNYPER-LTE».
5.3.4 STRANDARD INSTALLATION
The standard installation of the CV-Log-35 on the wall should be, as close as possible to the well opening, but not further
than 1.5 m from the pressure sensor(s) connection(s) on the valve.
The minimum signal strength is - 80 dBm for optimum data communication at the valve level.
To Next Page
Loading...
