CELTIS – 10.2007 –
GB
A.4
SAFETY
FOREWORD
CLAAS Tractors are designed and built to give you optimum
service over many years. They are designed to provide the
most comfortable and safe working conditions.
A frontal loader must never be fitted on the rollbar
tractor if the tractor does not have a protective system
against falling objects.
However, accidents can easily happen in agricultural work. It
is important to know the dangers and how to avoid them.
We respectively draw your attention to certain aspects
that merit constant attention (non exhaustive list).
PRECAUTIONS BEFORE STARTING
Caution is the best guarantee against any risk of
accident.
The driver must be fully familiar with the tractor and must
understand all the controls, their position and their purpose.
This manual must be read carefully.
If the tractor is used by anybody other than the owner, he
must be given all explanations required to allow him to work
safely.
The driving position must be clean (instrument panel, steering
wheel, floor and pedals).
Footsteps must be clean (no mud) to avoid slipping when
climbing or descending.
Use the steps and handles provided when getting into or out
of the tractor.
Before starting the engine, make sure that all controls are in
the neutral position, particularly the power take-off lever.
Only run the engine in well ventilated areas.
Make sure there is nobody nearby before starting the
tractor.
Fully release the handbrake before starting.
Do not start work if the tractor is not working properly.
FAILURE TO COMPLY WITH
RULES FOR SAFETY AND USE
Any violation of the safety seals will invalidate any claims for
liability against CLAAS for the entire delivery.
Any assembly of the CLAAS frontal loader over and above
the recommendations of the CLAAF rate in force at the date
of purchase shall result in the annulment of the CLAAS
guarantee for the entire delivery.
001hsn03
001hsn04
Any modification of a part of the CLAAS delivery, or use of a
tool or element installed on the frontal loader not originating
from CLAAS, shall result in the annulment of the CLAAS
guarantee for the entire delivery.
Use only spart parts and accessories that are in conformity
with CLAAS recommendations.
Do not modify your frontal loader or subject it to modification
by a third party without obtaining prior written permission from
CLAAS. Failure to comply with these rules may make your
frontal loader dangerous. In the event of damage or injury,
CLAAS's liability may not be invoked.
The guarantee ceases immediately if the standards, the
instructions or the maintenance of the frontal loader given in
this assembly notice document and instructions for use are
not respected.
To Next Page
Loading...
Need help?
General