CELTIS – 10.2007 –
GB
B.14
PROVISION FOR THE INSTALLATION OF A
CONTROL CASING IN THE CAB
ATTACHMENT OF THE CASING SUPPORT
To make it easier to install casing supports in the cab, threaded
holes exist on the cab side and right stay, under the caps
(I)
.
-
Distance apart:
120
mm
-
Screw diameter:
M10
CABLE ROUTING
A trap door
(B)
is provided in the right lower part of the window to
run the cables.
OPERATION:
-
Turn the quick-release fastener
(1)
through
1/4
.
-
Twist the crosspiece
(2)
, then remove the block of foam
(3)
.
-
Position the wires of the control box and replace parts
(1)
and
(2)
. If the wiring does not take up much space, replace the
foam
(3)
.
-
Replace the crosspiece
(2)
.
-
Close the rear window.
RECOMMENDATION
CLEANING
The cab needs very little upkeep. However, depending on the use
you make of your tractor, you should clean it regularly to ensure
the cab remains in good condition.
-
To clean the outside, use water containing detergent and a jet
of water to rinse it, in the same way as you would for a car.
-
For the inside, sweep up all traces of earth and clean with a
sponge and water to which detergent has been added.
Important: The
3
uts
(4)
are not provided to attach anything
other than a brake gauge cover
841bsn19
841bsn20
841bsn21
842bsn00
The cab should be kept impeccably clean,
particularly the windows and mirrors, to obtain
maximum visibility both when working and
when travelling.
2
1
2
3
4
4
To Next Page
Loading...
Need help?
General