EasyManuals Logo

Claas CELTIS 436 User Manual

Claas CELTIS 436
51 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #34 background imageLoading...
Page #34 background image
CELTIS 10.2007
GB
B.5
ALARMS
RED "PRIMARY ALARM" LIGHTS
Emergency stop light
This goes out as soon as the engine is running. It
comes on along with one of the following lights:
Or when the forward speed is greater than
45
km/h.
Battery charge warning light
This goes out as soon as the engine is running.
If it comes on, check the condition and tension of
the alternator belt. If these are normal, the alternator or
regulator may be defective Have these components checked
by an authorised CLAAS agent.
Engine oil pressure warning light*
This goes out as soon as the engine is running.
If it comes on, stop the engine immediately and
check the engine oil level.
-
If the level is too low, below the minimum marker, top up
with oil.
-
If the light remains on or if the oil level drops again, consult
an authorised CLAAS agent.
Engine coolant temperature warning light
If the coolant temperature warning light comes
on, stop the engine immediately. This means
that it is overheating; in this case, carry out the
following operations:
1-
Clean the radiator and radiator cover grills.
2-
Check that the water pump belt is not stretched or
broken.
3-
Check the coolant level.
To carry out these operations, refer to chapter
L
"Maintenance".
Hydraulic circuit (doubler) oil pressure warning
light*
When this light comes on during use, it indicates
that there is insufficient oil pressure in the hydraulic system.
With the front axle engaged, select the low range on the
hydraulic doubler; If the light goes out, you may return to the
garage in these conditions to have the hydraulic system
checked.
If the light stays on, stop the engine immediately and call in
an approved CLAAS agent.
Transmission oil temperature warning light*
When this light comes on during use, it means that
the (hydraulic) transmission oil temperature is too
high.
-
Stop the engine immediately.
-
Check for obstruction of the oil cooler at the front of the
tractor and clean if necessary.
Restart the engine. If the light comes on again (cooler clean)
stop the engine immediately and consult an approved CLAAS
repairer.
Hand brake warning light*
This warning light indicates that the hand brake is
engaged (applied). Engaging a gear, when the
engine is on and the hand brake applied, activates the buzzer
and the emergency stop light. Release the hand brake and
the audio warning will stop.
*
Audio warning and emergency stop light associated with this function.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Claas CELTIS 436 and is the answer not in the manual?

Claas CELTIS 436 Specifications

General IconGeneral
BrandClaas
ModelCELTIS 436
CategoryTractor
LanguageEnglish

Related product manuals