47
EASY: CRUISE PILOT
To set throughput, drive the combine into the standing crop so that the loss
monitors are full. Now check the losses. Are these losses acceptable? If not
then increase or decrease the sensitivity to show what is acceptable.
During unloading the CRUISE
PILOT automatically changes to
CRUISE CONTROL mode which
gives a constant speed, this will be
7% - 15% slower than the current
forward speed.
TIP. Use the QR code on the back of the booklet to get the video for setting
up CEBIS in the field.
Adjust the rotor loss
sensitivity so that the loss
triangles are shown 3/4 up
to the solid line.
To Next Page
