CHASSIS 5.9
Heater coil
Removal
1. Park the machine on firm level ground.
2. Stop the engine, chock the wheels and disconnect
the battery.
3. Refer to the blower motor removal procedure and
get access to the heater housing.
4. Clamp the two hoses (1) and (4) to the heater coil
(3), remove the hose clips (2) from the hoses and
disconnect the two hoses from the heater coil.
5. Slide the heater coil out of the housing (5).
Installation
1. Installation is the reverse of the above procedure.
2. Remove the clamps from the heater hoses (1) and
(4).
3. Start the engine, check the hoses (1) and (4) for
leaks.
4. Stop the engine and check the coolant level, fill to
correct level as necessary.
5. Test the blower motor before fitting the seat.
6. After fitting the seat, test the joystick controls.
To Next Page