Why is the time of day flashing on my Clack Valves Water System?
If the time of day is flashing on and off on your Clack Valves Water System, it's likely due to a power outage. Reset the time of day. If the PC Board has battery back up present the battery may be depleted.
Why is my Clack Valves WS1.5 delivering hard water?
If you're getting hard or untreated water from your Clack Valves Water System, here's what might be happening: * The bypass valve might be open or faulty. Make sure it's fully closed, or replace it. * High water usage could have exhausted the media. Check your program settings for abnormal water usage. * The meter might not be registering. Remove it and check for rotation or any foreign material. * There might be a fluctuation in water quality. Test the water and adjust the program values accordingly. * The regenerant tank might be empty or have a low level of regenerant. Add the proper regenerant to the tank. * The control might be failing to draw in regenerant. Refer to Trouble Shooting Guide number 12. * There might be an insufficient regenerant level in the regenerant ta...
General warnings and safety precautions for installation and service of control valves.
Detailed steps for disassembling, inspecting, and reassembling the drive assembly.
Steps for disassembling and inspecting drive cap assemblies for 1.5" and 2" valves.
Procedure for removing and inspecting main and regenerant pistons.
Disassembly and inspection guide for injector components.
General| Model | WS1.5 |
|---|---|
| Type | Water Softener Valve |
| Operating Pressure | 20-125 psi |
| Max Operating Pressure | 125 psi |
| Max Operating Temperature | 110 °F |
| Valve Body Material | Noryl |
| Material | Noryl |
| Rinse Flow Rate | 5 gpm |
| Meter | Yes |
| Connection Size | 1.5 inches |
| Meter Size | 1.5 inches |
| Drain Line | 3/4 inches NPT |
| Brine Line | 3/8" |
| Distributor Pilot | 1.05 inches OD |
| Valve Type | Piston |
| Backwash Flow Rate | 25 gpm |
| Service Flow Rate | 37 gpm |
| Bypass | Available |
| Flow Rate | 37 gpm |
| Inlet/Outlet | 1.5" NPT |
To Next Page
