EasyManuals Logo

Clack CF1044-3B User Manual

Clack CF1044-3B
22 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #11 background imageLoading...
Page #11 background image
F I L O X S e r i e s F i l t e r
Installation Operation Maintenance Manual
FILOXWS1-3B APRIL 2011 \page 11
7.0 COMMISSIONING
7.1 INTRODUCTION
It is recommended that the commissioning of the plant is undertaken by a trained
service engineer, who will be able to put the plant into service quickly, and most
efficiently. However, if the services of an experienced engineer are not available,
following the steps outlined below will result in the system being properly commissioned.
7.2 Setting the Time of Day
Press Set Hour
set the clock to the Closest Hour by Using the Up and
Down buttons. An arrow points to PM after 12. after Power failure the time of day
will need to be reset. Press SET HOUR to exit
The filter regeneration cycles have been factory programed.
The time of day for regeneration to take place has been entered as 2.00 AM and
this can be altered depending on site requirements.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Clack CF1044-3B and is the answer not in the manual?

Clack CF1044-3B Specifications

General IconGeneral
BrandClack
ModelCF1044-3B
CategoryWater Filtration Systems
LanguageEnglish

Related product manuals