clarion
APA250145012001
SETTING
THE
GAIN
After completing the installation, follow these steps to set the Gain Control and then
perform the Final System Checks.
1.
Tum the Gain Control all the way counter-clockwise.
2.
Tum the vehicle's Ignition Switch to the ON position. Then tum the ON/OFF
Switch on the source unit to the ON position. Set all Tone or Equalization Controls
to
"flat" positions and
turn
Loudness off.
3.
Playa
CD or Tape and set the Volume Control at 75%
of
full level.
NOTE:
If
the system uses an equalizer set all frequency controls to the "flat"
position.
4.
Slowly increase the Gain Control. Stop when you hear a slight distortion
of
audio.
SETTING
THE
CROSSOVER
The Clarion amplifiers feature fully adjustable crossovers.
To
set the crossovers, fol-
low these steps:
1.
Using the X-Over Mode Switch, select the desired mode: LP for Low Pass, HP for
High Pass or OFF for Full Range.
2.
Using the Freq (Hz) Selection Control, select the desired frequency.
SETTING
THE
BASS
BOOST
1.
Initially set the Bass Boost control
to
its OFF position.
2.
Listen to a variety
of
music styles (e.g., Rock, Rap, etc.) and switch the Bass Boost
control ON until a noticeable increase in low bass response is realized.
CAUTION:
If
you hear a "pop" (due to speaker over-excursion) adjust switch
to
lower the Bass Boost
to
prevent speaker damage.
11
To Next Page
Loading...
Need help?
General
