8. IN CASE OF DIFFICULTY
Water droplets may form
on
Let dry for about 1 hour with the power on.
the internal lens when the
car is parked
in
a humid
place.
Reset button
Consult your store of purchase.
Replace with a compact disc with no scratches.
Clean the compact disc with a soft cloth.
Replace with a fuse of the same amperage. If
the fuse blows again, consult your store of
purchase.
Eject the compact disc before loading the new
one.
Wipe the dirt off with a soft cloth moistened with
cleaning alcohol.
Incorrect wiring.
Compact disc is heavily
scratched or warped.
Compact disc is dirty.
Another compact disc is al-
ready loaded.
The microprocessor has Turn off the power, then
malfunctioned due to noise, press the
[RELEASE]
etc. button and remove the
DCP.
Press the reset button for
about 2 seconds with a
thin rod.
DCP or main unit connec-
tors are dirty.
Power does not turn
on.
(No sound is pro-
duced.)
9. ERROR DISPLAYS
If an error occurs, one of the following displays is displayed.
Take the measures described below to eliminate the problem.
A CD is caught inside the CD deck and is
not ejected.
A CD cannot be played due to scratches,
etc.
This is a failure
of
CD deck s mechanism
and consult your store of purchase.
Replace with a non-scratched,
non-warped-disc.
If an error display other than the ones described above appears, press the reset button. If the problem
persists, turn off the power and consult your store of purchase.
12
08165
To Next Page
Loading...
Need help?
General
