8 DB245
xxx-xxxx-xx
English
Remote control unit
Inserting the Batteries
1. Turn the remote control unit over, then slide
the rear cover in the direction of the arrow.
2. Insert the AA (SUM-3, IECR-6/1.5V) batteries
that came with the remote control unit facing
in the directions shown in the figure, then close
the rear cover.
Notes:
Using batteries improperly can cause them to ex-
plode. Take note of the following points:
• When replacing batteries, replace both batteries
with new ones.
• Do not short-circuit, disassemble or heat batteries.
• Do not dispose of batteries into fire or flames.
• Dispose of spent batteries properly.
Rear side
AA (SUM-3, IECR-6/1.5V)
Batteries
Rear cover
7. REMOTE CONTROL
DB245_EN_Pg02-17 20/11/03, 12:16 PM8
To Next Page
Loading...
Need help?
General
