English
25 DUZ388RMP
Operations Common to Each Mode
● Setting the contrast
You can adjust the display contrast to match the
angle of installation of the unit.
∗ The factory default setting is “10”.
(Adjustment level: 1 to 16)
2-1. Select “CONTRAST”.
3-1. Press the [w] or [z] button to adjust the
contrast.
● Displaying the settings
The number of indicator of this unit decreases,
you can see the state of current settings at any
operation mode.
2-1. Select “SETTINGS”.
3-1. Press the [w] or [z] button to display the
state of current settings.
∗ When the setting is selected, after 1 second
the current state will be displayed.
● Setting the button illumination
2-1. Select “COLOR”.
3-1. Press the [w] or [z] button to select the
color type in the following orders:
“COLOR SCAN” ↔ “INDIGO BLUE” ↔
“SURF BLUE” ↔ “SILKY WHITE” ↔
“AQUA GREEN” ↔ “FRESH GREEN” ↔
“LEAF GREEN” ↔ “WARM AMBER” ↔
“PASSION RED” ↔ “VIVID PINK” ↔
“PALE PINK” ↔ “DARK VIOLET” ↔
“PURE PURPLE” ↔ “USER COLOR1” ↔
“USER COLOR2” ↔ “USER COLOR3” ↔
“COLOR SCAN” ...
•Setting COLOR SCAN mode
As selecting “COLOR SCAN”, the color
automatically changes.
∗ The factory default setting is “COLOR SCAN”.
∗ After 3 seconds the color changes to the other.
•Setting USER mode
The factory default setting is “RED 8” (red),
“GREEN 8” (green), “BLUE 8” (blue).
As selecting “USER COLOR 1, 2, 3”, press the
[ ] button to enter the setting.
1. Press the [x] or [v] button to select
“RED”, “GREEN” or “BLUE”.
2. Press the [w] or [z] button to select from 0
to 8.
3. Press and hold the [ ] button for 2 seconds
or longer to store the color in memory and
return to the previous mode.
To change adjustment setting
1. Press and hold the [DISP] button for 1
second or longer to switch to the
adjustment selection display.
2. Press the [x] or [v] button to select
the “item name”.
“CONTRAST”
↔
“SETTINGS”
↔
“COLOR”
↔
“CODE”
↔
“SCRN SVR”
↔
“MESSAGE
INPUT”
↔
“SCROLL”
↔
“DIMMER”
↔
“BLINKLED”
↔
“TEL-SEL”
↔
“TEL-SP”
↔
“TEL-SW”
↔
“SYSTEM CHECK”
3. Press the [w] or [z] button to select the
“desired setting value”.
∗ In the case of display blinking “ENT”, you
can press the [ ] button to adjust the
setting value.
∗ After completing settings, press the [DISP]
button to return to the previous mode.
To Next Page
Loading...
