Clarion DXZ938R User Manual

26 DXZ938R
English
OFF ➜ ON ➜ MUTE ➜ OFF...
● OFF:
This unit continues normal operation even
when the cellular phone is used.
Note:
• If conncting a hands-free kit, please ensure the
setting is ON to receive the telephone audio
through the system.
● ON:
You can listen to your telephone calls from
the speakers connected to this unit.
∗ When listening to your calls on your car
speakers, you can adjust the volume by turn-
ing the [ROTARY] knob.
● MUTE:
The sound from this unit is muted during
telephone calls.
4. Press the [TITLE] button to return to the pre-
vious mode.
Setting Auto Volume
1. Press and hold the “TITLE” button for 1 sec-
ond or longer and enter “ADJ” mode
2. Press the [a] or [d] button to select
the”CALIBRATE”
3. Press the “PLAY/PAUSE” button and
“START” is displayed.
4. Keep driving speed 50km/h and press the
“PLAY/PAUSE” button.
5. “CALIBRATION” is flush for 2seconds in dis-
play.
6. If calibration is successful display indicate
“SUCCESSFUL” and sound long beep, or if
calibration is not successful display indicate
“FAILED” and sound 2 times a short beep.
7. If you failed, repeat steps 3 to 6.
Note:
• When installing this device or transferring it into
another vehicle, for the sake of safety, always
have this work done by the store of purchase or
your nearest Clarion dealer. Installation requires
specialized techniques and experience.
Operations Common to Each Mode
Setting Auto Volume sensitivity
1. Press and hold the “TITLE” button for 1 sec-
ond or longer and enter “ADJ” mode
2. Press the [a] or [d] button to select the
“A-VOL SENS”
3. Turn the “ROTARY” knob clockwise or coun-
terclockwise to make the adjustment.
The adjustment steps are below 6 steps, Off
➜ Low ➜ M-L ➜ Mid ➜ M-H ➜ High.

Clarion DXZ938R Specifications

Radio Specifications

FM receiving frequency range	87.5 to 108 MHz (0.05 MHz steps)
MW receiving frequency range	531 to 1602 kHz (9 kHz steps)
LW receiving frequency range	153 to 279 kHz (3 kHz steps)

CD Player Specifications

frequency response	5 Hz to 20 kHz (± 1 dB)
signal to noise ratio	100 dB (1 kHz) IHF-A
dynamic range	96 dB (1 kHz)

General Specifications

output power	4 x 31 W (DIN 45324, +B=14.4V)
power supply voltage	14.4 V DC (10.8 to 15.6 V allowable)
power consumption	Less than 15 A

Weight and Dimensions

main unit weight	1.7 kg
remote control unit weight	30 g (including battery)
main unit dimensions	178 (W) x 50 (H) x 155 (D) mm