No
Ball-point pen
Roughness
No
Proper way to hold
the compact disc
Removing the disc
This unit has been designed specifically for play-
back of compact discs bearing the mark.
CD ROMs cannot be played. Some CDs recorded
in CD-R/CD-RW mode may not be usable.
To remove the compact disc from its storage
case, press down on the center of the case and
lift the disc out, holding it carefully by the edges.
Note:
•
Do not use commercially available CD protection sheets or discs equipped with stabilizers, etc. These may
get caught in the internal mechanism and damage the disc.
Always handle the compact disc by the edges.
Never touch the surface.
To remove fingermarks and dust, use a soft cloth,
and wipe in a straight line from the center of the
compact disc to the circumference.
New discs may have some roughness around the
edges. The unit may not work or the sound may
skip if such discs are used. Use a ball-point pen,
etc. to remove roughness from the edge of the disc.
Note on compact discs
Never stick labels on the surface of the compact
disc or mark the surface with a pencil or pen.
5.HANDLING COMPACT DISCS
Do not use any solvents such as commercially
available cleaners, anti-static spray, or thinner
to clean compact discs.
Do not use compact discs that have large scratches,
are misshapen, or cracked, etc. Use of such discs
will cause misoperation or damage.
Do not expose compact discs to direct sunlight
or any heat source.
To Next Page
Loading...
Need help?
General
