Clarion M309 - Cell Phone Interrupt and AUX Input Settings

Operations Common to Each Mode
English
25 M309
3-1. Press the [ ] or [ ] button to select
“RIGHT” or “LEFT”.
•RIGHT: Telephone calls can be heard on
the front right speaker connected to this
unit.
•LEFT: Telephone calls can be heard on
the front left speaker connected to this
unit.
● Cell phone interrupt setting
If you connect this unit and your cell phone with
an optional cable, you can listen to your calls on
your speakers.
When the AUX input jack on the front panel is
used to connect an AUX BLUETOOTH BB
(BLT370) (sold separately):
∗ The factory default setting is “OFF”.
2-1. Select “TEL-SW”.
3-1. Press the [ ] or [ ] button to select
setting.
“OFF” ↔ “ON” ↔ “MUTE”
•OFF: This unit continues normal
operation even when the cell phone is
used.
•ON: Telephone calls can be heard from
the speakers connected to the unit.
∗ When listening to calls on your speakers,
turn the [ROTARY] knob to adjust the
volume.
•MUTE: The sound from this unit is muted
during telephone calls.
Note:
• If connecting a hands-free kit, make sure the
setting is ON to receive telephone audio through
the system.
● Performing memory reset
This function allows you to reset adjusted
settings in the ROM.
The stored settings like preset channels,
passwords adjusted areas, ISR memories,
adjust mode settings and audio mode settings
can be formatted by this function.
Note:
• The settings will remain in the ROM even if you
turn the power off or press the reset button.
2-1. Select “RESET”.
3-1. Press and hold the [ ] button.
This unit will be restarted automatically.
● Performing a system check
This function allows you to perform a system
check from the adjust mode when required.
2-1. Select “SYSTEM CHECK”.
3-1. Press and hold the [ ] button (1 sec.).
“SYSTEM CHECK” appears in the display,
then the unit returns to the previous
operation mode.
AUX function
This system has an external input jack(AUX) on
the front panel and the rear AUX terminals. So
you can listen to sound and music from external
devices connected to this unit.
● Selecting AUX mode
1. Press the [SRC] button to select “AUX 1” or
“AUX 2”.
● Selecting AUX IN sensitivity
Make the following settings to select the
sensitivity when sounds from external devices
connected to this unit are difficult to hear even
after adjusting the volume.
∗ The factory default setting is “MID”.
1. Press and hold the [DISP] button (1 sec.).
2. Select “AUX SENS”.
3. Press the [ ] or [ ] button to select
“HIGH”, “MID” or “LOW”.
Note:
• When AUX mode is selected, AUX IN sensitivity
can be set.
M309_ENG.book Page 25 Monday, February 23, 2009 3:04 PM