4. OPERATIONS
VT1010E 13
Note:
When closing the display panel, do not let cords or other items get caught between the
display and the overhead housing. Doing so can seriously damage the screen.
For safety, close the LCD panel when you are not using it.
HANDLING DISCS
To keep a disc clean, do not touch the play side (non-label side).
Do not attach sticky notes to or put tape on a disc.
Keep discs away from direct sunlight and heat.
Store discs in a protective disc case.
To clean the disc, wipe the disc outwards from the center with a
clean cloth.
TURNING THE PLAYER ON
1. Turn the ignition to either ACC or ON.
2. Press the power button ( ) on the player or on the remote.
If no disc is in the drive, it displays: “NO DISC.”
3. To change input sources, press SRC and alternate among
A/V input sources: DVD, AV IN1 (3.5mm input terminal) and AV IN2 (second
audio-video source).
Additional AV sources are optional must be connected.
Note:
You cannot insert a DVD into the slot if you’ve selected an alternate audio-video
source (AV IN1 or AV IN2).
TURNING THE PLAYER OFF
To turn the power off, press the power button ( ).
If a CD or DVD is playing when you turn the power off and back on again, the player
continues playback from where you stopped.
Note:
Once the player is turned off, you cannot eject the DVD or CD in the player.
CHANGING THE IMAGE ASPECT RATIO
A common display setting to change is screen mode, which controls the aspect ratio used
to display images.
PLAYING A DISC (DVD OR CD)
1. Put the headphones on your head and turn the headphone power on.
2. Assuming the power is on, insert a DVD into the player. The player displays
To Next Page
Loading...
Need help?
General
