16 XH5210/XH5410/XH7110
English
Owner’s Manual
Two-channel full-range or subwoofer system (XH5210)
In this application, the XH5210 is used to drive two speakers.
Subwoofers
Full-range co-axial or
Component speakers
Subwoofer in stereo
• Set crossover mode switch to LP
• Set crossover frequency to ~80Hz
• Fine-tune as required
• 2Ω min stereo / 4Ω min mono
Full-range speakers or components in stereo
• Set crossover mode switch to OFF
Components speakers in stereo with separate subwoofer amp
• Set crossover mode switch to HP
• Set crossover frequency to ~200Hz for 4-inch speakers
~100Hz for 5.25-inch speakers
~75Hz for 6.5-inch speakers
~65Hz for 6 x 9-inch speakers
Subwoofers and component speakers at the same time
• Set crossover mode switch to OFF
• Install passive crossovers on subwoofers (inductor) and components (capacitor)
To Next Page
Loading...
