14
Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com
DC POWER
(For charging car batteries only.)
1. Start the engine. See page 11.
2. Connect the battery charging
leads to the battery.
• Clamp the red wire to the
posit
ive (+) terminal and the
black wire to the negative (-)
terminal of the battery. Do not
reverse these positions.
3. Connect the battery charging
le
ads to the generator.
DC OVER LOAD PROTECTOR
If the DC overload protector
activates, wait for a few minutes and
then press the reset button shown on
the right.
CAUTION: MAKE CONNECTIONS TO THE BATTERY AFTER STARTING THE
ENGINE.
WARNING: TO PREVENT THE POSSIBILITY OF CREATING A SPARK NEAR THE
BATTERY, DISCONNECT THE CABLE TO THE GENERATOR FIRST AND THEN
DISCONNECT THE BATTERY
WARNING: AFTER YOU HAVE CHARGED THE BATTERY, ALWAYS
DISCONNECT THE NEGATIVE LEAD FIRST.
To Next Page
Loading...
Need help?
General
