9
Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com
CHECKING THE ENGINE OIL LEVEL
1. Turn the oil filler cap
counterclockwise and remove
from the oil tank,
2. Clean the dipstick with a cloth.
3. Put the dipstick back into the oil
filler tube and then remove it
again.
• Do not screw it in when doing
this.
4. If the oil is below the ‘L’ level on
the dipstick, fill the oil reservoir to
the ‘H’ level on the dipstick.
• Oil Capacity (See
“Specifications” on page 21.)
• We recommend the use of
SAE30 oil in this generator.
5. Replace the oil filler cap.
WARNING: TO CARRY OUT THIS CHECK, PLACE THE GENERATOR ON LEVEL
GROUND WITH THE ENGINE SWITCHED OFF (O).
WARNING: TAKE CARE NOT TO TOUCH ANY HOT PARTS OF THE
GENERATOR WHEN CHECKING THE OIL LEVEL.
To Next Page
Loading...
Need help?
General
