12
Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com
ADJUSTING THE PRESSURE
1. Hold the rear of the nozzle and
slide the front of the nozzle
forwards for low pressure and
backwards for high pressure.
• Other ways to adjust the
pressure include varying the
distance you are from the
surface being cleaned or
adjusting the spray to a wider
angle (lowering the pressure).
USING DETERGENTS
Only use detergents recommended for use with pressure washers such as:
• CLARKE Traffic Film Remover which is a powerful ‘low foaming’
agent for car cleaning, patio cleaning etc.,
• CLARKE Wash & Wax.
1. Fill the detergent bottle with the required detergent.
2. Attach the detergent bottle to the gun assembly.
CONSUMABLES ETC
A range of suitable hoses, shampoo and traffic film remover are available
from your CLARKE dealer.
SHUTTING DOWN
1. Rotate the switch to the OFF (0) setting and remove the mains plug from
the power supply.
2. Squeeze the trigger on the gun assembly to remove any pressure in the
hose.
3. Disconnect the water supply hose and allow it to drain fully.
4. Disconnect the high pressure hose and allow it to drain fully.
WARNING: THE USE OF UNSUITABLE CLEANING AGENTS MAY ADVERSELY
AFFECT THE SAFETY OF THE MACHINE. DO NOT EXCEED THE CORRECT
OPERATING TEMPERATURE FOR THE DETERGENT IN USE.
To Next Page
Loading...
Need help?
General
