7
Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com
CONNECT THE HOSE ADAPTOR
1. Insert the Water inlet filter into the
water inlet,
2. Screw the supplied hose adaptor
onto the water inlet as shown.
CONNECT THE HIGH PRESSURE HOSE
1. Push the end of the high pressure
hose into the gun assembly as
shown.
• It will click into place when
secure.
2. Remove the travel cap from the
high pressure hose inlet.
3. Screw the other end of the hose
on to the outlet.
• Tighten the connector hand
tight only;- do not use a
spanner.
• Make sure the connection is
secure.
To Next Page
Loading...
Need help?
General
