9
Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com
OUTLET PRESSURE ADJUSTMENTS
PORTABLE COMPRESSORS
1. Pressure Adjusting Knob
2. Outlet Taps
3. Pressure Gauge
TO ADJUST OUTLET PRESSURE:
To increase pressure - turn knob (1)
clockwise. To decrease pressure - turn
knob (1) anticlockwise.
Outlet taps - slide knurled section (2) away
from body to open, push towards body to
close.
NOTE: Pressure Gauge (3). Pressure shown will differ by approximately 1
bar depending on whether the outlets are open/closed.
STATIONARY COMPRESSORS
These machines are not supplied with the facility to adjust outlet pressure. A
comprehensive range of airline accessories is available from your local
CLARKE stockist.
OVERLOAD BUTTON (SINGLE PHASE ONLY)
The electric motor is fitted with an automatic
overload detector which will stop the motor if an
overload is detected.
If this happens,
1. Switch off at the pressure switch (Push knob
down or turn switch).
• Allow the compressor to cool down for 5-10
minutes.
2. Press the Reset button shown on the right.
3. Switch on pressure switch (lift knob or twist switch).
If the overload trips repeatedly, it may indicate a fault with the compressor, in
this case you should contact the Clarke service department.
OTHER PRODUCTS WITHIN OUR RANGE In addition to Air Compressors from 3–40
cfm, we offer a vast range of air tools and airline equipment. Please ask your
local dealer for details of our range or a copy of our Power Products Catalogue
To Next Page
Loading...
Need help?
General
