16
Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com
WATER BUTT CONNECTION
This machine has the ability to draw its own water, meaning you can use water
not under pressure, such as rainwater collected in a water butt.
To do this you must carry out the following procedure.
1. Attach the filter to the end of the
pipe supplied.
2. Place the filter into the water butt.
3. Replace the fitted inlet connector
with the inlet connector supplied.
4. Connect the pick-up pipe to the
press
ure washer as shown.
• Tighten securely
5.
Open the suction valve shown.
6. Start the power washer. See
“Starting the power washer” on
page 13.
• Water is ejected from the
noz
zle as shown.
7.
When the water spray being
ejected is consistent and at high
press
ure close the self suction
valve.
8. Use the pressure washer as
nor
mal.
NOTE: Do not let the pressure
washer run dry.
To Next Page
Loading...
Need help?
General
