Why my Clarke PLS265 will not draw chemicals?
If your Clarke Pressure Washer isn't drawing chemicals, start by cleaning the chemical filter. If the chemicals are too thick, dilute them to the consistency of water. Ensure you're using a longer supply hose instead of a longer high-pressure hose.
Why is my Clarke PLS265 Pressure Washer leaking at the gun?
If you experience water leaking at the gun or spray wand connection of your Clarke Pressure Washer, check for worn or broken O-rings and replace them. Also, ensure the hose connection is tight.
Why is my Clarke PLS265 leaking water from the pump?
If you notice water leaking at the pump of your Clarke Pressure Washer, tighten any loose connections. The piston packings, worn or broken O-ring, pump head or tubes damaged from freezing should be replaced by your dealer.
Why Clarke PLS265 Pressure Washer pump pulsates?
If the pump of your Clarke Pressure Washer pulsates, clear the obstructed nozzle.
Guide on checking and topping up the pump's oil level.
Steps to check and fill the engine's oil level.
Procedure for checking the fuel level and inspecting the fuel strainer.
Definitions of key terms like PSI, GPM, CU, Bypass mode, etc.
How to change the spray pattern from narrow to wide.
Methods for adjusting water pressure using regulator, distance, and engine speed.
Procedures for safely shutting down the power washer after use.
Detailed steps for draining and refilling the pump's oil.
General| Brand | Clarke |
|---|---|
| Model | PLS265 |
| Category | Pressure Washer |
| Language | English |
To Next Page